[Gambas-user] gb.dwg started

[Martin]

ok, I try to use some similar poppler, it doesn't work. then I try 
coping the configure.ac from Reini bindings, it doesn't neither, even I 
change many options also run 'relink.sh' nothing seems to work. I show 
the outputs of a few tries.

|| Unable to met pkg-config requirement: libredwg >= 0.10.0
|| gb.dwg is disabled

|| Unable to met pkg-config requirement: libredwg >= 0.0.11
|| gb.dwg is disabled

|| Unable to met pkg-config requirement: libredwg >= 0.0.11
|| gb.dwg is disabled

Regards

On 18/12/20 1:19, Benoît Minisini wrote:
> Le 18/12/2020 à 00:40, Martin a écrit :
>> I did everything again from a new template and delete the directory 
>> created before (gb.dwg) when I do ./reconf at the end of the process 
>> it tells me that the component is disabled because it cannot find 
>> c_dwg.h, but it does. Did I forget to indicate it somewhere?
>>
>> Martin
>>
>
> I strongly suggest that, if libredgw relies on 'pkg-config', that you 
> rewrite your 'configure.ac' file following the one of the 'gb.poppler' 
> component.
>
> You are at the moment using the autoconf macros made for searching 
> directories from specific files, but I made macros for using 
> 'pkg-config' too. They are simpler to use.
>
> Then, as for the location of 'gb.dwg.so' and 'gb.dwg.component', I was 
> talking about the location of their installation (normally 
> '/usr/lib/gambas3'). This is where the IDE searches for components.
>
> Regards,
>
>