[Gambas-user] Error on launch of Gambas 3.0

[Paul Horechuk]

Just as a followup...

On February 22, 2008, Paul Horechuk wrote:
> On February 22, 2008, 2020 wrote:
> > Hello folk,
> >
> > 1): I installed the development packages, but I can not resolved the
> > disabled component gb.qte, any ideas.
> >
> > ************************************************************
> > THESE COMPONENTS ARE DISABLED:
> > - gb.qte
> > ************************************************************
>
> I've found that the QT Embedded functions are not what I normally use.
> These are usually if you develop for handhelds and phones.
>
> > 2): After the installation I ran gambas3, unexpected error;
> >
> > Settings.Load.59: Syntax error in settings file at line #20: Type
> > mismatch: wanted Integer, got String instead
> > 0: Settings.Load.59
> > 1: Settings._new.97
> > 2: Project.Main.143
>
> I had the exact same error last week. The best I could tell, it was an
> older version of the settings file. It didn't get replaced on the
> reinstall. I ended up doing:
> rm -rf /usr/local/share/gambas3
> rm -rf /usr/local/lib/gambas3
> rm -rf ~/.config/gambas
>
> The last one is the user environment as in /home/$USER/.config/gambas.
> One of these was for a prior version. Following this, a make install gave
> me a working system.
This error has occurred again. No changes were made to svn versions (stil 1077). The system was restarted and upon launching Gambas3, there were complaints about the settings. I did a rm -rf ~/.config/gambas and gambas3 was able to run. Perhaps the "Save Project" is corrupting the settings file?
>
> My environment was Kubuntu 7.04 64bit.
>
> > Thanks in advance.
> >
> > Sylvain.



-- 
Paul Horechuk
      Think Free 
Use Open Source Software

______________________________________________________________________
This email has been scanned by the MessageLabs Email Security System.
For more information please visit http://www.messagelabs.com/email 
______________________________________________________________________