[Gambas-user] Gambas was live on Twitch

[Benoît Minisini]

Le 11/09/2015 04:20, Kevin Fishburne a écrit :
> On 09/10/2015 10:02 PM, Benoît Minisini wrote:
>> Le 11/09/2015 03:52, Kevin Fishburne a écrit :
>>> On 09/09/2015 07:28 AM, Benoît Minisini wrote:
>>>> Hi Kevin, Looking quickly at your live twitch, I noticed that
>>>> apparently, if I'm not wrong, you are not aware of the difference
>>>> between: If A And B And C Then And: If A And If B And If C Then "And"
>>>> must be used for binary computation. "And If" should always be used
>>>> for tests. It is faster, as it only executes a test if the previous is
>>>> TRUE, while "And" always evaluates all its operands. I think you will
>>>> agree to save a few CPU cycles, do you? :-) Regards,
>>> That is an awesome tip. I actually had wondered if there was a way to do
>>> this, or if Gambas would abort subsequent tests automatically if one was
>>> found to be False. I didn't realize I could just stick multiple Ifs in
>>> there. Thanks!
>>>
>> By the way, do you use the IDE profiler to detect where you use most of
>> the CPU?
>>
>
> That sounds like something an actual programmer would do, so no. :) Is
> there a tutorial on the wiki that explains the basics? So far I've been
> optimizing as I go, but I haven't taken the time to do any real analysis
> to find problem areas. I'd probably start by examining the execution
> time of each procedure call in the "main loop", then getting more granular.
>

Just run it, and look at the tables it shows you.

-- 
Benoît Minisini